Need More Help - Craftsman 900.74547 Manuel D'utilisation

Tool runs slowly
• Check that the cassette housing can
rotate freely. Carefully clean it if
necessary.
• Check that the cutting line does not
protrude more than approximately 4-3/8
inches (111mm) from the cassette. If it
does, cut it off so that it just reaches
the line trimming blade.
Automatic line feed does not work
• Keep the tabs depressed and remove
the cassette from the cassette housing
in the trimmer head.
• Pull the cutting line until it protrudes
approximately 4-3/8 inches (111mm)
from the cassette. If insufficient cutting
line is left on the spool, install a new
spool of cutting line.
• Align the tabs on the cassette with the
cut outs in the housing.
• Push the cassette onto the housing
until it snaps securely into place.
• If the cutting line protrudes beyond the
trimming blade, cut it off so that it just
reaches the blade.
If the automatic line feed still does not
work or the spool is jammed, try the
following suggestions:
• Carefully clean the cassette and
housing.
• Remove the spool and check if the
lever in the cassette can move freely.
• Remove the spool and unwind the
cutting line, then wind it on neatly
again. Replace the spool into the
cassette.

NEED MORE HELP?

You'll find the answer and more on managemyhome.com – for free!
Find this and all your other product manuals online.
Get answers from our team of home experts.
Get a personalized maintenance plan for your home.
Find information and tools to help with home projects.