Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
D)
Ensure that the egg tray is in the correct position (on its supports) and that the cradle rows tilt freely in the two directions.
E)
Fill basin 5/a with lukewarm water. Pour the water into the corresponding opening at the
front left hand side of the incubator. Do this slowly, taking care not to allow the water to
overflow from the basin: too much liquid would increase in the humidity rate lowering the
hatching percentage. The second basin (5/b) will be used only for the hatching phase.
You can top up the basin(s) even when the incubator is working. If possible, do this
when the incubator is unplugged, as although the appliance is designed not to be
damaged by water, inadvertent spillage can damage the electrical components.
F)
Replace the lid. Ensure that the edge of the lower box locates perfectly with the slot in
the lid.
For both models it is possible to place the lid so that the openings for water filling are at
the front or at the back of the incubator.
G)
Insert the cover's plug into a suitable socket; the supply voltage of the electrical system
must be suitable for the incubator's voltage. Ensure that your hands are not wet while
performing this operation. The fan will start immediately, followed by the display that
shows the temperature inside the incubator. The yellow LED indicates that the resistor is
working. It will remain illuminated for 20-40 minutes, until the set temperature is
reached; it will then flash intermittently at 2-3 seconds intervals.
WARNING:
IF THE FAN IMPELLER DOESN'T START, IMMEDIATELY UNPLUG THE
INCUBATOR AND CONTACT THE SERVICE CENTRE.
The machine is pre-set at a temperature of 37,7°C, ideal for all species of birds. It is recommended you reset the temperature following the
instructions here below.
39
Publicité
Table des Matières
