Corrective Action - LG USNW096JRZ1 Manuel Du Propriétaire

Problem
The air conditioner
does not emit cool
air.
The fan speed
cannot be adjusted.
The temperature
cannot be adjusted.
The air conditioner
stops during
operation.
36
Possible Causes
Air is not circulating properly.
The air filter is dirty.
The room temperature is too
high.
Cold air is escaping from the
room.
The desired temperature is
higher than the current
temperature.
There is a heating source
nearby.
Fan Mode is selected.
Outside temperature is too
high.
The Jet Mode, or Auto
Operation Mode is selected.
The Fan Mode or Jet Mode is
selected.
The air conditioner is
suddenly turned off.
A power failure has occurred
during operation.

Corrective Action

• Make sure that there are no curtains,
blinds, or pieces of furniture blocking
the front of the air conditioner.
• Clean the air filter once every 2
weeks.
• See "Clean the Air Filter" for more
information.
• In summer, cooling the indoor air fully
may take some time. In this case,
select the Jet Mode to cool the indoor
air quickly.
• Make sure that no cold air is escaping
through the ventilation points in the
room.
• Set the desired temperature to a level
lower than the current temperature.
• Avoid using heat generators like
electric ovens or gas burners while
the air conditioner is in operation.
• During Fan Mode, air blows from the
air conditioner without cooling or
heating the indoor air.
• Switch the operation mode to cooling
operation.
• The cooling effect may not be
sufficient.
• In some operation modes, you cannot
adjust the fan speed. Select an
operation mode in which you can
adjust the fan speed.
• In some operation modes, you cannot
adjust the temperature. Select an
operation mode in which you can
adjust the temperature.
• The Timer Function may have timed
out, which turns the unit off. Check
the timer settings.
• Wait for the power to come back. If
you have the Auto Restart function
enabled, your unit will resume its last
operation several minutes after power
is restored.
EN