Precautions For Use; Cleaning And Maintenance - Eurotops 48113 Mode D'emploi

A.
INSTALLATION/ REPLACEMENT OF BULB
Instructions before installing or replacing the bulb:
- The cable must be disconnected from the socket.
- Place the lamp on a flat, stable and non-slippery surface.
- If the lamp was lit before, allow the lamp and the bulb to cool for at least 10 minutes before
any operation.
Characteristics:

Lamp: 230V 50Hz

2 LED bulbs (9W max each, E27 - not included)
B.
USE OF THE LAMP
Plug the lamp.
Note: There are 2 pull chains, under the lampshades, located respectively under the
lampholders. Use them to turn on or off the two bulbs inside the lampshades separately.
C.

PRECAUTIONS FOR USE

 Use the lamp indoors only.
 Before connecting the lamp to the mains, check that the voltage indicated on the rating plate
matches that of your electrical installation.
 Never exceed the maximum wattage for the bulbs and use the correct bulb base (refer to Part B:
Installation / Replacement of bulb.
 Do not pull on the cord, but on the plug to disconnect the lamp.
 Do not touch the lamp and its base with wet hands.
 Do not touch the bulb and shade when it is lit.
 Install the lamp away from moisture and away from flammable materials and heat sources.
 The lamp should be placed in a dry place, on a clean and stable surface.
 Never touch the switch with wet hands.
 Do not attempt to open the lamp to repair it. The electrical part can only be repaired by a qualified
electrician or a specialized workshop.
 Never look directly at the light source.
 The lamp is not a toy. Keep the lamp out of the reach of children and pets. Always disconnect the
lamp if left unattended.
 Do not cover the lamp when it is switched on.
 Handle the product with care. A blow, a shock, or a fall, even from a low height, can damage it.
 If you do not intend to use the lamp for a long time, remove the cable from the outlet.
D.

CLEANING AND MAINTENANCE


Before cleaning the lamp, unplug it and allow it to cool down for 10 minutes.

Clean the lamp with a soft, dry, lint-free cloth.

Avoid contact with water.

Do not use abrasive chemicals or detergents.

Keep the lamp away from dust, moisture and extreme temperatures.
WARNING: You should not dispose of this device with your household waste. A selective
collection system for this type of product is implemented by your local authorities. Please contact
your local authorities to find out how and where collection takes place. These restrictions apply
because electrical and electronic devices contain dangerous substances that have harmful effects
on the environment or on human health and must be recycled.
This symbol indicates that electrical and electronic devices are collected selectively. The symbol
shows a waste container crossed out with an X symbol.
Imported by EML- Trading name: Prodis 1 rue de Rome 93110 Rosny-sous-Bois-France/ Made in
PRC - Marketed by EUROTOPS VERSAND GMBH D-40764 LANGENFELD
English
2