Functions - CHICAGO Electric 98179 Installation Et Instructions D'utilisation

Perceuse extra robustes de 3/8 po
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

speciFicatiOns
Electrical Requirements 120 V~ / 60 Hz / 4.1 A
Motor Speed
Chuck Size
Chuck Type
unpacKing
When unpacking, check to make sure
that the item is intact and undamaged. If
any parts are missing or broken, please
call Harbor Freight Tools at the number
shown on the cover of this manual as soon
as possible.
instructiOns FOr
putting intO use
read the entire iMpOrtant
saFety inFOrMatiOn section
at the beginning of this manual
including all text under
subheadings therein before set
up or use of this product.
FrOM acciDental
OperatiOn:
turn the power switch of the
tool to its "OFF" position and
unplug the tool from its
electrical outlet before
assembling or making any
adjustments to the tool.
note: For additional information regarding
the parts listed in the following pages,
refer to the Assembly Diagram near
the end of this manual.
SKU 98179
For technical questions, please call 1-800-444-3353.
All manuals and user guides at all-guides.com
n
1500/min
0
3/8 Inch
Keyless Chuck
90SM
E194601
tO prevent
seriOus injury

Functions

1.
This drill is suitable for drilling opera-
tions.
2.
The Trigger can be locked in the ON
position for extended operation.
3.
The Keyless Chuck allows the op-
erator to install and remove drill bits
without the use of a separate key or
other tool.
Operating instructiOns
read the entire iMpOrtant
saFety inFOrMatiOn section
at the beginning of this manual
including all text under
subheadings therein before set
up or use of this product.
tool set up
FrOM acciDental
OperatiOn:
turn the power switch of the
tool to its "OFF" position and
unplug the tool from its
electrical outlet before
performing any inspection,
maintenance, or cleaning
procedures.
To insert a drill bit, hold the rear ring
of the Chuck (2) with one hand while turn-
ing the front ring with the other. Open the
jaws enough to allow the bit to slide in.
Turn the front ring the opposite direction to
tighten the jaws on the bit. Be sure the bit
is centered in the jaws. Tighten firmly by
hand.
tO prevent
seriOus injury
Page 9

Publicité

Table des Matières
loading

Table des Matières