Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Work piece and Work area set up
1.
Designate a work area that is clean
and well-lit. The work area must not
allow access by children or pets to
prevent injury and distraction.
2.
Route the power cord along a safe
route to reach the work area without
creating a tripping hazard or exposing
the power cord to possible damage.
The power cord must reach the work
area with enough extra length to al-
low free movement while working.
3.
Secure loose work pieces using a
vise or clamps (not included) to pre-
vent movement while working.
4.
There must not be hazardous ob-
jects, such as utility lines or foreign
objects, nearby that will present a
hazard while working.
general Operating instructions
1.
Plug the Power Cord (36) into a suit-
able outlet.
Direction
Lever
Trigger (32)
Lock ON Button
2.
Press the Direction Lever of the
Trigger (32) to determine the rotation
direction of the Chuck (2). Press to
SKU 98179
For technical questions, please call 1-800-444-3353.
All manuals and user guides at all-guides.com
the right side for clockwise Chuck
rotation. Press to the left side for
counterclockwise Chuck rotation.
3.
Squeeze the Trigger (32) to start the
tool. The Trigger has a variable speed
feature. Pressing it lightly will make
the tool operate slowly, pressing more
will cause the tool to operate faster.
4.
You can lock the Trigger in the ON
position by squeezing the trigger,
pressing in the Lock ON button, and
releasing the Trigger. The tool will
operate continuously. To stop the tool,
squeeze and release the Trigger.
5.
To prevent accidents, turn off the tool
and disconnect its power supply after
use. Clean, then store the tool in-
doors out of children's reach.
the Drilling Operation
1.
Use only well-sharpened bits that are
in good condition and appropriate to
the task.
2.
Use firm pressure when drilling, but
do not press too hard. Too much
pressure will not help the process
and will cause the bit to overheat,
may cause the bit to bend or break,
cause undue strain on the tool, and
may damage the bit or work piece.
Pressing too hard may stall the mo-
tor. WARNING: If the motor stalls,
release the Trigger immediately, to
prevent damage to the tool.
3.
Always drill in a straight line. Bending
or twisting the bit while drilling may
cause the bit to bend or break and
may damage the work piece.
4.
Back off your pressure when you are
about to penetrate the work piece.
Page 10
Publicité
Table des Matières
