Technical Support - Stop & Go 8 PLUS-MINUS CLIP Instructions De Montage

Masquer les pouces

Table Des Matières

Table des Matières

Les langues disponibles

Prior to

Function

Installation

installation

check

After installing the control device including the speaker housing, laying the high-voltage cable and attaching the stainless

steel contact plates, the setup should be retested to ensure that it functions correctly. Since the integrated sensor auto-

matically switches off the device if the vehicle is in use, you must ensure that the car is motionless before performing a

function check using a multimeter. Set "direct current – 300 V" and measure the voltage between the two stainless steel

contact plates (should read 250–300 V). If the function check is successful but voltage fails to build up after installation,

an installation error has occurred.

Blinking at regular intervals (approx. every 5 seconds) = OK: ultrasound is being emitted, high voltage has built up.

Fast blinking = voltage is building up/dissipating. Caution: residual voltage!

LED off = device is switched off.

Prior to

Function

Installation

installation

check

Do the button batteries (CR2477) have a voltage of at least 3 V? Regular testing of the battery voltage

is recommended.

Is the engine switched off?

Have all the plus stainless steel contact plates been installed so that they do not touch any other live

or earthed parts (risk of short circuit)?

Is the device completely still and not subject to any movement or vibration?

Has the position of the stainless steel contact plates on the cable been changed, damaging the copper core?

Prior to

Function

Installation

installation

check

*Switching the device on and oﬀ

Pull the slide contact (printed part)

half way out.

CR2477

(marked with a sticker)

Changing the CR2477 battery

Pull the slide contact (printed part) out completely. When inserting the batteries, pay attention to the polarity. The printed plus side of the battery should face

upwards so that the plus sign is visible after insertion of the button battery. Push the slide contact back in, keeping it straight!

Trouble

Circuit

Warranty

shooting

diagram

Trouble

Circuit

Warranty

shooting

diagram

Trouble

Circuit

Warranty

shooting

diagram

Function control light

Speaker housing

Control device/

slide contact*/

battery compartment

Fastening tunnell

Hinge

Slide out pin with suitable

Minus plate

device to open the hinge

Plus plate

Guide steps

Cable wall

Base

Fastening tunnell

Prior to

Function

Trouble

Installation

installation

check

shooting

IMPORTANT! Terms of the warranty (please keep in a safe place)!

Our 8 PLUS-MINUS CLIP High-voltage device with ultrasound comes with a 48-month functional warranty:

Any reasonable complaints within the warranty period from the date of purchase will be remedied free of charge,

either through repair or delivery of a replacement product at our discretion. In order for the warranty to apply,

our product must have been properly installed and maintained in accordance with our installation instructions.

To enable us respond to problems, please return the control device and installation invoice to us, initially at your

own expense.

Installation and removal costs will only be covered by us in the event that the device is proven to be defective.

Any claim under Section 5 of our General Terms and Conditions shall remain unaffected, subject to the condi-

tions set out therein.

Any damage caused by improper installation or incorrect, negligent or forceful operation shall invalidate the

warranty. There shall be no liability for consequential damage.

Technical changes and errors excepted.

Please fill in to claim against the warranty: For warranty claims to be processed, you must send us the filled in coupon

and the garage/installation invoice!

Garage stamp

Date of purchase