Homelite HHC35A Manuel Du Propriétaire page 6

ASSEMBLY
(For 100 and 150 Models Only)
6
These models are furnished with wheels and a front handle. Wheels, front handle,
and the mounting hardware is found in the shipping carton.
Tools Needed
• Medium Phillips Screwdriver
• 3/8" Open or Adjustable Wrench
• Hammer
1. Slide axle through wheel support frame. Install wheels on axle.
IMPORTANT: Place extended hub of wheel toward wheel support frame.
2. Place cap nuts on axle ends. Gently tap with hammer to secure.
3. Place heater on wheel support frame assembly. Make sure air inlet end of
heater is over wheels.
4. Place handle on top of fuel tank flange. Insert screws through handle, fuel tank
flange and wheel support frame. Attach nut finger tight after each screw is
inserted.
5. Tighten all nuts firmly.
Screw
Hot Air
Outlet
Fuel
Cap
Fuel
Tank
Flange
Wheel
Support
Frame
Wheel
Nut
Cap Nut
Figure 4 - Wheel and Handle Assembly, 100/150 Models Only
Handle
Extended
Hub
Axle
Air Inlet
100577