Safety Definitions; Safety Instructions For Operation - Hamron 609208 Instructions D'utilisation

1 Introduction
1.1 Product description
The product is a bicycle carrier with capacity to transport up
to 4 bicycles.
1.2 Intended use
The product is intended to be used on the towbar of a
vehicle to transport bicycles.
1.3 Symbols
Read the operating instructions carefully
and make sure that you understand the
instructions before you use the product.
Save the instructions for future reference.
2 Safety

2.1 Safety definitions

Warning! If you do not obey these instructions, there
is a risk of death or injury.
Caution! If you do not obey these instructions, there
is a risk of damage to the product, other materials or the
adjacent area.
Note! Information that is necessary in a given situation.

2.2 Safety instructions for operation

Warning! If you do not obey these instructions, there
is a risk of death or injury.
● Read and understand the instructions before you use the
product.
● Save these instructions and safety instructions for future
reference.
● Do not use the product for tasks other than its intended
purpose. The manufacturer cannot accept liability for any
damage that is a result of improper use.
● Do not use the product if parts are missing. Speak to the
retailer if the product if parts are missing.
● Do not use the product if it is damaged or is defective.
Speak to an authorized service center.
● Do not repair the product. A damaged or defective
product must be repaired at an authorized service center.
The manufacturer cannot accept liability for any damage
that is a result of unauthorized repairs.
2022_001
● Make sure that you install a separate license plate on the
product. The product conceals the license plate on the
vehicle.
● Make sure that the ignition in the vehicle is in the off
position and that the ignition key is removed before you
install the product.
● Make sure that the parking brake in the vehicle is
engaged before you install the product.
● Make sure that the maximum load for the axle on the
vehicle is not exceeded.
● Make sure that the maximum permitted load on the
towbar is not exceeded. The maximum permitted load for
the towbar must be at least 60 kg.
● Make sure that the towbar is of ST 52-3 or GGG 52 type.
● Make sure that the product is fully installed and that the
opening mechanism on the product is fully closed before
you put bicycles on the product or operate the vehicle.
● Operate the vehicle a short distance to check all screw
unions and connections after you have installed the
product to the vehicle. Tighten the screws if it is
necessary.
● Do not use the product at speeds over 120 km/h.
● Avoid sharp braking, sharp acceleration and sharp turns.
● Do not put more than 4 bicycles on the product.
● Be aware that the product increases the length and width
of the vehicle it is installed on when you put bicycles on
the product.
● Be extra careful when you reverse. The product increases
the total length of the vehicle.
● Do a check of all screw unions and connections regularly.
If the operating conditions are bad, do a check more
often.
● Clean the product regularly.
3 Operation
3.1 To install and use the product
● Follow the instructions in the illustrations for how to
install and use the product. (Figure 1–20)
Note! The product conceals the license plate on the vehicle.
A separate license plate must be installed on the product.
15