Stand Installation - Fox Spirit IQ390 Guide D'utilisation

Stand installation

1. Open the package, take out the product with foam still attached, and gently place it on
a desktop or table.
2. Take out the base and bracket, as well as three PM5*15mm screws, and lock the three
PM5*15mm screws on the bottom of the base.
3. Use the base bracket assembly assembled in step 2 to align with the slot of the machine
and buckle it down (Note: use your finger to move the quick release button upward to
take out the base bracket assembly)
Quick click button
Make sure the monitor is laid on a flat surface before removing the stand.
ENG-9
Screws PM5*15 mm x3