Basic Operation; Indicator Light - Fox Spirit IQ390 Guide D'utilisation

Basic Operation

Insert one end of the DP cable into your PC's graphics card. A HDMI cable may also
be used.
1. Connect the other end of the cable to the corresponding connector on your monitor.
Powe r Conne ctor
2. Connect the power cable to your monitor then connect the other end to your power source.
It is recommended that you use a surge protector with adequate voltage if a wall outlet cannot
be reachde directly.
3. Locate the power button on the monitor and press it to turn the monitor on.
FreeSync
The fe ature its e lf is off by default. In orde r to us e this fe ature, ple a s e note Set the Freesync
function in the OSD menu to on,you must have hardware with FreeSync capability, a DP/HDMI
cable, and the latest graphic drivers. To use this feature, connect your computer and monitor with
a DP/HDMI cable. After connecting, you may receive a prompt to enable the feature on your computer.
If you do not receive the prompt, you may need to enable the function in your graphics card menu.
See your graphics card manufacturer's documentation for instructions on how to turn on and/or
enable FreeSync.

Indicator Light

Solid blue light indicates power is on and the monitor is operating normally. Alternate flash red and blue
light indicates no video source ,no horizontal or vertical signal has been detectde or voltage is low. Please
ensure your computer is on and all video cables are fully inserted and/or connected.
DP Conne ctor
HDMI2 HDMI1 DP2
HDMI Conne ctors
ENG-13
DP1 AUDIO OUT
Audio Output
Indicator Light