Install The Canopy - Fanaway LD-0003-11/WH/GS Guide D'installation

INSTALL THE CANOPY

Loose ball joint via loosening the set screw. Insert the lead wires and down rod through canopy, and then
secure ball joint back to down rod.
INSTALL THE FAN TO MOUNTING BRACKET ON CEILING
1) Lift the fan to the ceiling and seat the ball joint in mounting bracket socket, make sure the tab on the
mounting bracket socket is properly seated in the groove in the ball joint.
2) Connect the male plug (Fan Motor) and female plug (Mounting bracket) together (No. 1 - Fig. 3).
3) Then attach the ceiling canopy (No.3– Fig. 1) onto the mounting bracket. Align the 4 holes and then install
the 4 screws.Tighten all four screws firmly.
Figure 4
7