Scope Of Use; Scope Of Supply And Optional Accessories; Location And Function; Installation - T.I.P. SPH 10000 Traduction Du Mode D'emploi D'origine

Translation of original operating instructions

3. Scope of use

This pool solar heater is designed to heat pool water. The unit has been developed for private use and not for in-
dustrial or commercial purposes. The unit must not be installed in the domestic water network (drinking water).

4. Scope of supply and optional accessories

Included in the product scope of supply are:
Solar heater with connections, hose clamps and a user manual.
Check the scope of supply for completeness. If possible, retain the packaging until your guarantee has expired.
Dispose of packing materials in an environmentally friendly manner.
Additional accessories may be required depending on the application. In our T.I.P. Pool range you will find other
useful accessories that simplify installation, improve maintenance and pool cleaning and make it more efficient;
e.g. solar pool liners from the SFF series, pool filter systems from the SPF series or pool pumps from the SPP se-
ries and pool hoses Ø 32 or 38 mm.

5. Location and function

Installation location of the pool heater
The pool heater should be placed on a stable, horizontal and solid base.
Make sure that the unit is always in full sunlight for best results.
Position the unit and connection hoses safely and sufficiently away from the pool so that there is no danger of
tripping.
How the pool solar heater works
The incoming water is pumped through the unit with the aid of an external pump, heated by solar energy and then
fed back into the pool. With the help of the telescopic feet, the alignment can be optimally adjusted with regard to
the angle of incidence.
Guide values for heating your swimming pool*
1 m³ water >
14 m³ water >
14 m³ water >
* Based on 10 hours of operation in direct sunlight (outdoor temperature approx. 20 °C) per day (may vary due to
weather changes). The pool was covered with a T.I.P. solar pool liner.

6. Installation

A pump and pool hoses (neither included in the scope of supply) are required to put the unit into operation.
Install the unit between the pump or sand filter and the return flow to the pool using additional pool hoses. Close
the inlet and return of the pump or filter circuit at the pool. Ensure that all lines carrying water are tightly sealed.
Now the solar heater can be installed in the circuit. To do this, proceed as follows:
Inlet and outlet are marked on the lower end of the heater, where the hose connections are also located. As seen
from the front, on the left side is the input "IN" (input coming from the pump) and on the right side is the outlet
"OUT" (outflow to the pool) (Fig. 1).
Fig. 1
1 day > max. 11.0 °C
1 day > max. 1.0 °C
5 days > max. 4.0 °C
2
8