T.I.P. SPH 10000 Traduction Du Mode D'emploi D'origine page 10

Translation of original operating instructions
Remove the union nut on the inlet and outlet. Now fit the enclosed seals on the hose connections as shown in
Fig. 2. Check the seal for correct fit, if necessary use some silicone grease for easier installation. Now connecting
pieces can be tightened with union nuts at the inlet and outlet. Avoid excessive force when tightening the union
nuts, this could possibly lead to damage.
Fig. 2
Now attach the pool hoses with the respective desired length to the connections and fix them with the help of the
enclosed hose clamps (Fig. 3). Avoid excessive force when tightening the hose clamps, this could cause damage.
Fig. 3
All connection lines must be tight, as leaking lines can impair performance and cause considerable damage. If
necessary, use suitable sealing material to ensure that the installation is airtight.
Do not use excessive force that can cause damage when tightening threaded unions.
In addition, the connection lines must not have any kinks or a reverse gradient; this can lead to considerable
power losses. Use connection lines that have the same diameter as the supply hose of the pump, (min. 32 mm).
Next, fold the telescopic feet outwards. Now set the desired height of the feet. You can change the height of the
unit as follows:
Turn the lower part of the feet slightly to the left (anti-clockwise) to loosen it. Pull the telescopic feet to the desired
length. Fix it by turning the lower part of the feet slightly to the right (clockwise) until the feet are firm again, as de-
scribed in Fig. 4.
Fig. 4
3
9