Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
C
O N N E C T I O N S
Connection to a TV (Interlace)
- Connecting to your TV using Component video cables.
- You will enjoy high quality and accurate color reproduction images. Component video separates
the picture element into black and white(Y), blue(P
images. (Audio signals are delivered through the audio output.)
1
Using component video cables (not included), connect the
COMPONENT VIDEO OUT terminals on the rear of the DVD
player to the COMPONENT IN terminals of your TV.
2
Using the audio cables, connect the AUDIO (red and white)
OUT terminals on the rear of the DVD player to the AUDIO (red
and white) IN terminals of your TV.
Turn on the DVD player and TV.
3
Press the input selector on your TV remote control until the
Component signal from the DVD player appears on the TV
screen.
4
Set the Video Output to Progressive Out Off in the Display
Setup menu. (See pages 52 to 54)
You can use the VIDEO SEL. button to change the Video
Output mode. (See page 12)
Note
- If you want to connect to an Amplifier, please refer to the Amplifier connection page. (See pages 18 to 19)
- The component terminal of your TV may be marked "R-Y, B-Y, Y" or "Cr, Cb, Y" instead of "P
depending on the manufacturer. The number and position of terminals may vary depending on the TV set.
Please refer to the user's manual of your TV.
), red(P
) signals to present clear and clean
B
R
Audio Cable
RED
WHITE
ENG-14
GREEN
RED
BLUE
RED
WHITE
Component cable
(not included)
RED BLUE
GREEN
, P
, Y"
R
B
Publicité
Table des Matières
