Maintenance Of Silk'n Silhouette; Cleaning Silk'n Silhouette; Troubleshooting - Silk-n Silhouette Mode D'emploi

7.2. After treating with Silk'n Silhouette™
When Silk'n Silhouette™ session has been completed turn Silk'n Silhouette™ off by unplugging the AC/
DC ADAPTOR cord from the electrical outlet.
After each session it is recommended that you clean your Silk'n Silhouette™ device, especially the
TREATMENT SURFACE (See: 8.1 "Cleaning Silk'n Silhouette™").
After cleaning, it is recommended to store your Silk'n Silhouette™ device in its original box, and keep it
away from water!

8. Maintenance of Silk'n Silhouette™

8.1. Cleaning Silk'n Silhouette™

After each treatment session, it is necessary to clean your Silk'n Silhouette™ device, and especially the
TREATMENT SURFACE. Unplug Silk'n Silhouette™ before cleaning
Unplug Silk'n Silhouette™ before cleaning.
Use absorbent paper (such as toilet paper or hand drying napkins) to gently wipe the gel residue off the
TREATMENT SURFACE.
Never immerse Silk'n Silhouette™ or any of its parts in water!

9. Troubleshooting

"My Silk'n Silhouette™ does not start."
Make sure the POWER ADAPTOR is properly connected to the Silhouette™ device.
Make sure the POWER ADAPTOR is plugged into an electrical outlet on the wall.
"Heat energy is not emitted and I don't feel any heat emitted from the device even
though I pressed the TREATMENT MODE SELECTION BUTTON"
Heat will not be emitted if the TREATMENT SURFACE is not attached to your skin. This is a safety feature.
Make sure the device is tightly pressed to your skin before starting treatment.
Do not attempt to open or repair your Silk'n Silhouette™ device. only authorized
Silk'n™ personnel are permitted to perform repairs.
10