Table des Matières
Publicité
English
Technical Information
Recommended water pressure
Max. water pressure
Recommended hot water temp. 120° - 140° F*
Max. hot water temp
Flow rate
spout
handshower
71513xx1
04766xx0
71514xx1, 04366xx0 2.0 GPM (7.6 L/min)
*
Please know and follow all applicable local plumbing
codes when setting the temperature on the water heater.
Installation Considerations
• For best results, Hansgrohe recommends that
this unit be installed by a licensed, professional
plumber.
• Please read over these instructions thoroughly
before beginning installation. Make sure that
you have all tools and supplies needed to
complete the installation.
• The mounting surface must be finished and made
watertight before installation of this trim kit.
• Keep this booklet and the receipt (or other proof
of date and place of purchase) for this product in
a safe place. The receipt is required should it be
necessary to request warranty parts.
3-hole models only:
• This trim kit requires rough valve 06607000.
2
15 - 75 PSI
approx. 5.6 GPM @ 44 PSI
1.8 GPM (6.8 L/min) max.
1.75 GPM (6.6 L/min) max.
145 PSI
176°F*
4-hole models only:
• This trim kit requires rough valve 06646000.
• Protection against backflow is provided by a
check valve in the handshower hose and by an
automatically resetting diverter.
• 71514xx1,
handshower is for use with automatic
compensating valves rated at 1.7 GPM
(6.4 L/min) or less.
• 71513xx1, 04766xx0: This handshower
is for use with automatic compensating valves
rated at 1.4 GPM (5.3 L/min)or less.
• This unit is not anti-scald. In Massachusetts, or
if required by local plumbing code, install an
approved remote pressure balance valve or
other approved anti-scald device.
• To prevent scald injury, the maximum output
temperature of the shower valve must be no
higher than 120°F (49°C). In Massachusetts,
the maximum output temperature can be no
higher than 112°F (44°C).
04366xx0
only:
This
Publicité
Table des Matières
