Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
All manuals and user guides at all-guides.com
Initial Setup (Ready to Play)
Please make all cable or antenna connections before powering on.
Connecting
For ANT./Cable
Connect the cable from
Antenna/Cable to the VHF/
UHF terminal on the unit.
For DSS/Cable Box
Connect the OUT jack on
your cable box to the VHF/
UHF terminal on the unit
with a RF cable.
WARNING:
Overtightening "Nut type" RF
coaxial cables may damage jacks.
Finger tighten only.
Initial Setup (Ready to Play)
1
Plug the unit power cord into
an AC wall outlet.
Press POWER* on the remote or unit.
2
The unit comes on and auto channel
and clock set starts.
CH AUTO SET PROCEEDING
• If you use a cable box, turn it on and set it
to the Public Broadcasting Service (PBS)
channel in your time zone. If you use a
DSS receiver, it must be turned off.
AUTO CLOCK SET
PROCEEDING
CANCEL : PRESS STOP KEY
10
27DF62-K(E) (P10-11 Initial Setup).p65
UNIT
VHF/UHF
3
Settings are made automatically.
When setup is done, this screen
appears.
If AUTO CLOCK SET IS
INCOMPLETE screen appears, set
the clock using MANUAL CLOCK
SET procedure on next page.
10
IN from
ANT./CABLE
VHF/UHF
Cable TV
Converter Box
IN from
ANT./CABLE
2 / 6 / 2002 WED 12 : 00PM
DST : ON
SETT I NG : CH 1 0
AUTO CLOCK SET
COMPLETED
AUTO CLOCK SET
I S I NCOMPLETE
PLEASE SET CLOCK BY
PRESS I NG ACT I ON KEY
2002/04/15, 18:39
Publicité
Table des Matières
