Operating Instructions - Sonnenkonig CERAMICO HELSINKI Manuel De L'utilisateur

3 Operating instructions

Ensure the heater is placed on a flat and level surface. Never use the heater on
GB
chairs, beds or other soft/unstable surfaces.
Check the household voltage to ensure it matches the appliance's rated specificati-
on. Be sure to plug into a 220~240V, 50Hz/60Hz outlet.
1. I/O
Press the Main Power Switch to «I» position for entering the Standby Mode.
2. ON/OFF
When in Standby Mode, press the «ON/OFF» key. The heater will start operating and
enter into «HI» mode. When you press the key again, the heater will stop working and
the fan turns off 30 s later.
3. Mode Selection
Press the «Mode» key and the heater will run in «LO» mode. When you press it again,
the heater will turn back to «HI» mode with its corresponding indicator lamp lighting up.
4. SENSOR Mode
Press the «SENSOR» key to activate the «SENSOR» mode, and press it again to change
back to «normal» mode. Once the «SENSOR» mode is activated, the indicator lamp for
this function will be on.
If the SENSOR cannot detect any motion within the area (distance ≤ 2 m) for more than
2 mins, the heater will stop working.
Once the SENSOR detects someone entering the area (distance ≤ 2 m), the heater turns
on again automatically with a buzzer sound.
5. TIMER
Press the «TIMER» key to activate the timer function, set the timer for the working time
with the maximum being 7 hours.
Each step adds 1 hour to the set time.
6. LOCK
When you press the «LOCK» key for 4 seconds, the control panel will be locked, except
for the ON/OFF button.
Press the «LOCK» key again for 4 seconds to unlock the device.
36