Operating Instructions; Cleaning And Maintenance - Sonnenkonig TOWER-LCD Mode D'emploi

3 Operating instructions

• Press the Main Switch to the "I" position and the LCD display lights up, which means the
heater is ready.
GB
• Power: Press the Power button to choose LO/HI/AUTO/OFF/LO cyclic order.
LO-Mode: The heater works with low power
HI-Mode: The heater works with high power
AUTO-Mode: You can set the temperature from 5 – 32 °C. The temperature is preset to 24
°C. When the room temperature is lower than the set temperature, the heater works on HI
power. When the room temperature is higher than set temperature, the heater works on LO
power.
• OSC: Press it to activate the oscillation function. Press it again and the heater stops oscillation.
• Timer: When pressing it, the timer display flashes and you can press the "+" or "-" button
to set the timer from 0.5/1/1.5 to 8 hours in 0.5-hour intervals. In LO and HI mode, you can
set the timer with its information on the display. In AUTO mode, you can set the timer and 6
s after setting, the display returns to the set temperature. You can press TIMER to check the
remaining hours.
• "+" Press this button to increase the temperature or the timer. It will increase automatically
when it is pressed longer.
• "-" Press this button to decrease the temperature or the timer. It will decrease automatically
when it is pressed longer.
Note:
- Please note that this heater has a safe tip-over switch. If the appliance is knocked over, the
heater will stop working until it is placed in an upright position again.
- The remote control has the same functions as the control panel.

4 Cleaning and maintenance

Ensure that the device is switched off before cleaning or maintaining it.
- Before maintaining, please pull out the plug, and make sure the heater has become cool.
- Please use a soft cloth to wipe dust off the surface of the heater. If the surface is too dirty, it
is better to wipe it with water which is colder than 50 °C and mixed with a neutral detergent.
- Do not use gasoline, thinner or any other liquids which can easily damage the surface.
- Please let the heater cool and dry before packing it. Place it in a dry and ventilated place.
30