Haverland IGLU UV Manuel D'instructions page 25

- Press the "Fan Speed" button to select wind speed.
5. UV Function.
Press Timer button for more than 10 seconds to turn on/off the UV light.
5. Timer operation
Timer ON setting:
- When the air-conditioner is OFF, press the "Timer" button and select a desired ON time through the temperature and
time setting buttons.
- ON time can be regulated at any time between 0-24 hours.
Timer OFF setting
- When the air-conditioner is ON, press "Timer" button and select a desired OFF time through the temperature and
time setting buttons.
- OFF time can be regulated at any time between 0-24 hours.
6. Continuous Drainage
Internal Tank Water Full Alarm Function
The inner water tank in the air-conditioner has one water level safety switches, it controls the water level. When
water level reaches an anticipated height, the water full indicator lights up. When the water is full, please remove the
rubber blockage from the drainage hole at the bottom of the unit and drain all water outside.
Continuous Drainage
- When you plan to leave this unit unused for a long time, please remove the rubber blockage from the drainage
hole at the bottom of the unit and drain all water outside.
- The continuous drainage does not need to be applied when the unit working at the COOL or DEHUMIDIFY mode.
The unit can evaporate the condensated water automatically by the splash motor. Make sure the drainage holes are
stemmed well.
- If water splash motor is damaged, continuous drainage can be used. To connect the drain hose (not supplied) to
the bottom drain hole (Fig.6), the unit can also work well.
- If the splash motor is damaged, the intermittent drainage can also be used. Under this condition, when the water
full indicator lights up, please connect a drain hose ( not supplied) to the bottom drainage hole, then all the water in
the water tank will be drained outside. The unit can also work well.
(Drain hose not supplied)
- 7 -