Zyxel NWA-3160 Mode D'emploi page 4

1.1 LEDs
• The PWR/SYS LED turns steady green when the power is connected.
• The ETHN LED turns on if the ETHERNET port is properly connected, and blinks when
there is traffic. The LED turns green if the connection is at 10Mbps, and turns yellow if the
connection is at 100Mbps.
If the ETHN LED does not turn on, check the cable connection to the
ZyXEL Device's ETHERNET port. Ensure your computer's network card is
working properly.
2 Access the Web Configurator
Use Internet Explorer 6.0 and later or Netscape Navigator 7.0 and later
versions with JavaScript enabled and pop-up blocking disabled.
2.1 Set Up Your Computer's IP Address
Note down your computer's current IP settings before you change them.
ENGLISH
4