Making Minor Adjustments Between Doors - Samsung RF23HTEDBSR Manuel D'utilisation

Masquer les pouces Voir aussi pour RF23HTEDBSR:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

CAUTION
Both control levers must be touching the fl oor to
avoid possible personal injury or property damage
because of tipping.
If the right side is lower, perform the same
procedure, but with the right control lever.
It is diffi cult to remove the cover leg
front from the refrigerator, so we do not
recommend making small adjustments
with the control lever.
Instead, refer to the next page for the best
way to make minor adjustments to the
doors.
MAKING MINOR ADJUSTMENTS
BETWEEN DOORS
Remember, a leveled refrigerator is necessary for
getting the doors perfectly even.
If you need help, review the previous section on
leveling the refrigerator.
The left door is fi xed.
To make minor adjustments between
doors, adjust only the right door.
1. Pull out the freezer drawer ( 1 ) to reveal the
lower hinge ( 2 ).
2. Insert the supplied allen wrench (5/32" (4 mm))
( 3 ) into the shaft ( 4 ) of the lower hinge.
3. Adjust the height by turning the hex wrench
( 3 ) clockwise ( 
DOWN
DOWN
UP
UP
 ).
DA68-02954B-00.indb 16
DA68-02954B-00.indb 16
Adjustment part
Adjustment part
Fixed part
Fixed part
 ) or counter clockwise
English - 16
(2)
(2)
(3)
(3)
(4)
(4)
(1)
(1)
When you turn the hex wrench counter-
clockwise ( 
 ), the door will move up.
4. After adjusting the doors, insert the supplied
fastener ( 6 ) using a pliers ( 5 ) in the gap
between the hinge-grommet ( 7 ) and the lower
hinge ( 8 ).
The number of fasteners you'll need to insert
depends on the gap.
2 fastener are enclosed with the
refrigerator.
The thickness of each fastener is 0.04".
WARNING
• Keep the fasteners used to level the refrigerator
doors out of the reach of children.
Do not let children play with them.
- There is a risk of death from suffocation if a
child swallows a fastener.
(3)
(3)
2014. 5. 20.
2014. 5. 20.
4:35
4:35

Publicité

Table des Matières
loading

Table des Matières