Black & Decker Pfister Petaluma 531 Serie Mode D'emploi page 4

11
11C
11C
11A
11D
11A
11A
11 PULL-OUT HOSE ATTACHMENT
From underneath sink, push Quick Connector (11A), located on the end of the Pull-Out
Hose (11B) firmly upward onto the Receiving Tube (11C), until unable to push any further.
Pull down on the Quick Connector (11A). If the housing and the Inner Collet (11D)
separate slightly but do not pull off, the Receiving Tube (11C), quick connect is secure.
To remove Pull-Out Hose (11B), Push up on Quick Connector (11A). Holding Plastic
Collet (11D) in place, pull downward on Quick Connector (11A) until Tube (11C) is free.
12 WEIGHT ATTACHMENT
12
12B
12D
Discard Cardboard Fitting (12B) from Weight (12A). Place Weight (12A) above the
beginning of hose bend (12C) at the spout side (as shown in shaded area). Secure
Weight (12A) with Screws (12D).
13 SOAP DISPENSER INSTALLATION
ENGLISH
11D
11B
11A
12A
12C
4
13
From above sink, insert threaded Shank (13A) of soap dispenser body through Foam
Gasket (13B) and sink hole. From below sink, tighten Nut (13C) and thread on Bottle
(13D) to Shank (13A).
14 SOAP DISPENSER HEAD INSTALLATION
14
Pour in liquid soap (not included) into the Shank Orifice (14A). Insert Pump Mechanism
(14B) into Soap Dispenser Body (14C). Install Dispenser Head (14D) by pushing firmly
onto Pump Mechanism (14B).
15 UNIT START UP
13A
13B
13C
13D
14D
14B
14A
14C