Hendi 211410 Mode D'emploi page 5

Grounding installation
This appliance is classified as protection class
I and must be connected to a protective ground.
Grounding reduces the risk of electric shock by
providing an escape wire for the electric current.
How to use
• Clean the inside of tank with a non-abrasive de-
tergent and rinse with clean water.
• Make sure the tap is closed.
• Fill the appliance up to the MAX level indicated on
the inner wall of the reservoir.
• Fasten the lid securely by turning it until it locks
into place.
• Plug the cord into the electric outlet, then turn
the power switch "ON". Indicator of power switch
lights up.
After use / Empty the urn
• Switch the appliance off by pulling the plug out of
the wall socket.
• Place a container under the tap.
Cleaning and maintenance
• Always pull the plug from the wall socket before
cleaning the urn.
• If the boiler is subjected to heavy use, you will
need to de-scale it at regular intervals.
• Never immerse the boiler in water or other liquid
cleaning products.
This appliance is fitted with a power cord that has a
grounding wire and grounded plug. The plug must
be plugged into an outlet that is properly installed
and grounded.
• Use the temperature setting knob to select the
desired temperature (Maximum temperature
setting is 100°C). The actual temperature can
differ from the selected temperature. Orange
LED lights up.
• When the liquid has reached the selected tem-
perature, the orange LED lights off.
• Water boiler now ready to be served.
Note: This appliance is not suitable for use with
milk and chocolate milk.
• Open the tap and drain the liquid out of the urn.
• When the boiler has been emptied, close the tap.
• Clean the boiler with a damp cloth.
• Never use abrasive or caustic cleaning products.
• Always ensure the electrical connections remain
absolutely dry.
• When you drain off dirty water, leave the tap open
and rinse the boiler with clean water.
EN
5