Gas Connections - Napoleon ROGUE Serie Manuel D'utilisation

g c
aS onnectionS
To a propane cylinder
Only use a 20 lb. (9.1 kg) propane cylinder constructed and marked
in accordance with the Specifications for LP gas Cylinders of the U.S.
Department of Transportation (D.O.T.) or the Standard for Cylinders,
Spheres and Tubes for Transportation of Dangerous Goods and
Commission, CAN/CSA-B339, as applicable.
Only use a gas pressure regulator specified by Napoleon. The
regulator must supply a pressure of 11 inches water column (0.39
psi) and have a QCC1 type fitting.
The cylinder connection device must be compatible with the
connection for this outdoor appliance.
The propane cylinder must have:
• a shutoff valve with a QCC1 connection
• a safety relief device
• a collar to protect the valve
• a listed Overfill Protection Device
Hook-up and installation
• Check the cylinder for dents or rust, and have it inspected by
your propane supplier.
• Never use a cylinder with a damaged valve.
• Set cylinder into the hole in bottom of shelf. (1)
• The cylinder must fit properly into the tank retaining ring. (2)
Proper hose connection
• Ensure the gas regulator hose has no kinks.
• Clip the hose to side panel using the supplied retainer clip. (3)
• Do not route the hose in close proximity to the drip pan.
• Remove the cap or plug from the cylinder fuel valve.
• Insert the black QCC1 regulator nipple onto the QCC1 fuel valve.
Hand tighten to right. Do not use tools. (4)
• Ensure the hose does not contact any high temperature surfaces
of the grill because it will melt and cause a fire.
• Leak test all joints prior to operating the gas grill. See "LEAK
TEST" on page 8.
WARNING! Do not store a spare propane cylinder under or near this gas appliance.
WARNING! Never use a propane cylinder that is beyond 80% full.
WARNING! Follow all specifications and instructions exactly to prevent fire, explosion, property damage,
personal injury, or death.
6
| Getting Started
1
2
3
4
Napoleon.com | Rogue Series Grills
!