Lamp Replacement - LITELINE AutoGuard GMSCR150 Serie Mode D'emploi

OPERATION
1. Turn on the power to activate the light/camera, the light is now in start up mode. Light will turn on for 1 minutes, then return to
Energy-saving mode.
2. To test, walk through the sensor's detection area.
3. Your body heat will activate the sensor and turn the light on, the light will turn the face to the detected zone.
4. After the light is activated, keep out of detection area and the light will switch off automatically after 3 minutes. The light will be
activated again when detecting any heat/motion.
NOTE: Pre-set to Energy-Saving mode, fi xture will track heat/motion, light will not turn on during daylight hours.

LAMP REPLACEMENT

1. To isolate the unit, fi rst switch off the unit from the mains power.
2. Unscrew the lamp cover and take the old lamp out and replace with new one.
3. Close the lamp cover and tighten the screws.
OVERVIEW
Channel Button
Channel Indicator
Mode Control
The wireless receiver supports up to 4 cameras working at the same time.
• Channel Setup:
You may slide the channel switch 1, 2, 3, and 4 to either ON, to enable the channel, or OFF, to disable the channel.
• Channel-looping Switch:
You may slide the channel-looping switch to either L, to enable the channel-looping function, or M, to disable it. In channel-looping
mode, the channels are looped and shown on the monitor/TV one by one every 5 seconds.
All manuals and user guides at all-guides.com
WIRELESS TV/PC RECEIVER
AV Output
Power Socket
Antenna
USB 2.0 Port