LITELINE AutoGuard GMSCR150 Serie Mode D'emploi page 3

BULB INSTALLATION
1. Remove the lamp cover of the luminaire and install a 150W or
300W (depending on model) J-type lamp.
2. Ensure that the gasket is seated properly on fi xture.
3. Reinstall the lamp cover and tighten the screws.
INSTALLATION OF MOTION TRACKER
1. Remove the mounting plate from the back of the fi xture by removing
the screw at the bottom.
2. Remove silicon cover from channel switch.
3. Set the channel you prefer.
4. Secure the silicon cover back in place.
Channel 1 Channel 2
5. Install mounting strap onto a junction box. The minimum installation height is 2 meters. And the maximum height is 3 meters.
6. Fit the mounting plate onto the mounting strap and tighten the screws.
7. Feed the cable through the back mounting plate.
8. Connect the green wire from the power source to the green wire on
the fi xture. Connect the black wire from the power source to the black
wire on the fi xture. Connect the white wire from the power source to
the white wire on the fi xture.
9. Install the fi xture to the back mounting plate.
10. Seal fi xture to the wall with an outdoor waterproof silicone.
All manuals and user guides at all-guides.com
Channel 3 Channel 4
3
1
2
1
Channel switch
ON
2
1
2
Mounting Plate
2
2 - 3 m
L
black
N
white
MIN 75°C SUPPLY CONDUCTORS
3
1