LITELINE AutoGuard GMSCR150 Serie Mode D'emploi

User's Manual
GMSCR150 & GMSCR300 Series
IMPORTANT: THE INSTALLATION OF THIS FIXTURE MUST BE DONE BY A QUALIFIED ELECTRICIAN.
WARNING: BEFORE ATTEMPTING ANY INSTALLATION OR MAINTENANCE, ENSURE THAT THE ELECTRICAL SUPPLY IS SWITCHED OFF AND THE CIRCUIT
FUSES REMOVED OR THE CIRCUIT BREAKER IS IN THE "OFF" POSITION.
• This fi xture must be grounded.
• Do not mount the luminaire against fl ammable surfaces.
• The motion detector will not operate correctly if it is installed:
(I) Near the outlet of a central heating boiler.
(II) Pointing directly at moving vehicles.
(III) Within sight of refl ection from moving water.
(IV) Where other lamps could shine onto the detector.
• Check the total load of the circuit. Including this luminaire. Does not exceed the rating of the circuit cable.
NOTE: This highly responsive unit may occasionally activate due to rapid environmental changes. Allow for approximately 30 seconds warm-up time
before the sensor resumes normal activity.
WARNING: THIS FIXTURE WILL BECOME HOT WHEN IN USE. ALLOW BULB TO COOL BEFORE TOUCHING.
NOTE: DO NOT REMOVE THE TAPE UNTIL YOU FINISH THE INSTALLATION. IF THE TAPE COMES OFF THE LIGHT, PLEASE REPLACE IT OR HOLD THE
LIGHT HEAD TO AVOID SWIVELING AND DAMAGE THE PRODUCT.
WARNING: RISK OF FIRE, BURNS, AND SHOCK, KEEP AWAY FROM FLAMMABLE EXPLOSIVE OR COMBUSTIBLE MATERIALS, TURN OFF, AND ALLOW
TO COOL BEFORE RE-LAMPING KEEP AT LEAST 3 FEET AWAY FROM ADJACENT MATERIALS.
CAUTION: RISK OF EXPOSURE TO EXCESSIVE ULTRAVIOLET (UV) RADIATION, DO NOT OPERATE WITHOUT COMPLETE BULB ENCLOSURE (LENS) IN
PLACE.
CAUTION: TO REDUCE RISK OF FIRE, USE MAX. 150W OR LESS TYPE T3 BULB 120V 60HZ FOR 150W FIXTURES; USE MAX. 300W OR LESS TYPE
T3 BULB 120V 60HZ FOR 300W FIXTURES. Suitable for wet location use.
CAUTION: RISK OF ELECTRIC SHOCK. Keep lamp at least 16 feet from pools and spas.
DO NOT SUBMERSE! KEEP PROTECTIVE GLASS IN PLACE!
All manuals and user guides at all-guides.com
ENGLISH