JVC DLA-VS2100 Manuel D'instructions page 45

Adjustments and settings in the menu (continued)
Color Management
Clear Motion Drive
Off
Mode 1
Mode 2
Mode 3
Mode 4
Lens Aperture
Lamp Power
Normal
High
[1-2-1] Sharpness
Sharpness
Detail Enhance
All manuals and user guides at all-guides.com
It is possible to set the color of the screen to the preferred color and save it.
To "[1-2-2] Color Management" of the submenu.
It improves video images with fast movements to produce clear video images with little
residual image retention.
For PC signals, the "Clear motion Drive" cannot be set.
(*) If "Short Delay" is set to "On", "Mode 3" and "Mode 4" are not available.
Moreover, it may happen that the image is distorted in some scenes, or light and dark
flashes occur. In this case, please choose "Off", etc., and then a setting of your choice.
Settings: Off, Mode 1, Mode 2, Mode 3, Mode 4
Off
Black insertion weak
Black interpolation strong
Interpolation weak
Interpolation strong
Adjusts the amount with which the optical iris is squeezed. A setting of 0 means fully
opened.
Settings: (Dark) -15 to 0 (bright)
Settings: (Dark) -3 to 0 (bright)
It is possible to change the brightness of the lamp.
(*) If continually used with "High", the lamp will become dark earlier.
(*) The more one lets the interior temperature of the device rise due to generation of heat,
the less the level of tolerance against high temperatures.
(*) For about 60 seconds after the lamp is lit, the lamp cannot be switched off.
Settings: Normal, High
Normally this setting is chosen.(160W drive)
In a bright room, when the video is hard to see, this setting is chosen.(220W drive)
Emphasizes the outlines of video images. Please adjust to your preference.
Values: 0 to 50 (clear)
It makes minute details of the video images stand out. Please adjust to your preference.
Values: 0 to 50 (strong)
VS21 RS50 RS50
RS50 RS50
VSNL
ENGLISH
[Off]
[0]
[0]
[Normal]
45