Basic Functions; Adjusting Volume And Sound; Radio - Philips MAGNAVOX AZ1200 Mode D'emploi

BASIC FUNCTIONS

Switching the set on and off
Set the POWER control to the desired sound source:
CD, TUNER, or TAPE.
The set is switched off when the POWER control is set to
O O F F F F /TAPE and the keys of the tape deck are released.
Note: If you use batteries, always be sure to switch the set off
after use. This will avoid unnecessary power consumption.

Adjusting volume and sound

Adjust the volume using the VOLUME control.
™ Display indication: Volume level from 0 to 32 (AZ 1205 only).
Increase and decrease the bass level by pressing DBB.
The bass level can also be emphasized if you place the set against
a wall or shelf. Do not cover any vents; leave sufficient room
around the unit for ventilation.
Radio – tuning to radio stations
1 Set the POWER control to TUNER.
2 Select the wave band using the BAND selector.
3 Tune to the desired radio station by using the TUNING knob.
Improving RADIO reception
For FM stations, pull out the telescopic antenna. To improve the
signal, incline and turn the antenna. Reduce its length if the signal
is too strong (very close to a transmitter).
For AM stations, direct the built-in antenna by turning the whole
set. The telescopic antenna is not needed.

RADIO

AZ 1200 AZ 1205
AZ 1201
9