Description; Catalogue Numbers; Operating Elements - Asco ControlD Manuel D'installation

INSTALLATION
1.

DESCRIPTION

From open-loop control to closed-loop control to cascaded process control – everything is possible with the C
controller module. As a stand-alone component, the controller module is designed to control proportional valves by regu-
lating the current in the valve's solenoid coil. The maximum value of the solenoid coil's current is automatically determined
with the auto-adapt function. Higher precision requirements can be met by controlling flow, temperature, pressure, force
etc. using additional analog feedback inputs. More complex requirements are satisfied through a cascaded control with
feedback from the actuator and a process variable.
The C
D can be installed on a DIN rail in a control cabinet. The analog inputs and outputs are connected with screw
ontrol
terminals.
A serial RS232 or a USB interface allows communication with a PC. All configurations (setpoint settings in all commonly
used signal variables, open-loop or closed-loop control, cascaded control etc.) are simple to set up with the Windows-
based AscoDigiCom software, offering optimum adaptation of the proportional valve to the control system. Visualisation
(scope function) of the analog inputs and outputs and the PID control variables allows easy adjustment of the control
parameters to match specific applications.
Three buttons and a three-digit LED display on the module enable manual setpoint setting and display of feedback without
the need for PLC control during start-up.
Additional LEDs show the operating state and any error messages (e.g. low voltage, overvoltage, setpoint not reached)
that may occur.
1.1

CATALOGUE NUMBERS

Description
C control device - 12 V DC / 2 A
D
ONTROL
C control device - 24 V DC / 2 A
D
ONTROL
C control device - 24 V DC / 200 mA
D
ONTROL
1.2

OPERATING ELEMENTS

Green LED
Yellow LED
Red LED
Display
Operating buttons
catalogue no.
60300117
60300118
60300119
Green LED
Setpoint ≠ feedback
OFF:
ON: Setpoint = feedback
Flashing: Overtemperature
Yellow LED
OFF: Normal
ON: Manual operation
Flashing: AUTOSAFE enabled
Red LED
OFF: Normal
ON: Low voltage
Flashing: Overvoltage
DP-IM14152-5
GB
D
ontrol