GE Appliances GDT550HSD2SS Directives D'installation page 13

Dishwasher Installation
STEP 17: CONNECT POWER SUPPLY
If a power cord with plug is already installed proceed to
Step 18.
WARNING:
If house wiring is not 2-wire with ground, a ground must be
provided by the installer. When house wiring is aluminum, be sure
to use UL-Listed anti-oxidant compound and aluminum-to-copper
connectors.
ADVERTENCIA:
Si el cableado doméstico no cuenta con un cable de 2 hilos con
conexión a tierra, un instalador debe realizar una conexión a tierra.
Cuando el cableado doméstico es de aluminio, asegúrese de usar
un compuesto antioxidante y conectores de aluminio a cobre
aprobados por UL.
#10 Hex head screw from the screws set aside in Step 1.
strain relief.
• Locate the 3 dishwasher wires, (white, black and green) with
wire nuts of appropriate size to connect incoming ground to
green, white to white and black to black.
Check to be sure that wires are not pinched under the cover.
mounting bracket.
NOTE: Do not remove the
Junction Box Bracket.
Ground
White (Green)
Black
Figure AA
NOTE: All ground screws, brackets and wires must remain
intact.
STEP 18: PRETEST CHECKLIST
Review this list after installing your dishwasher to avoid
charges for a service call that is not covered by your
warranty.
• Check to be sure power is OFF.
• Open door and remove all foam and paper packaging.
• Locate the Owner's Manual set aside in Step 1.
• Read the Owner's Manual for operating instructions.
• Check door opening and closing. If door does not open and
close freely, check for proper routing of spring cable over
tension. See Step 2.
• Check to be sure that wiring is secure under the dishwasher,
not pinched or in contact with door springs or other
components. See Step 17.
• Check door alignment with tub. If door hits tub, level
dishwasher. See Step 13.
• Pull lower rack out, about halfway. Check to be sure it does
leveling legs. See Step 13.
• Check door alignment with cabinet. If door hits cabinet,
reposition dishwasher. See Step 12.
• Check that door spring does not contact water line, fill hose,
wiring or other components. See Step 12.
• Verify water supply and drain lines are not kinked or in
contact with other components. Contact with motor or
dishwasher frame could cause noise.
• Turn on the sink hot water faucet and verify water
temperature. Incoming water temperature must be between
120°F and 140°F. A minimum of 120°F temperature is
AC
Jumper
required for best wash performance. See "Prepare Hot Water
Line," page 5.
• Add 2 quarts of water to the bottom of the dishwasher to
lubricate the pump seal.
Ground
Screw
• Turn on water supply. Check for leaks. Tighten connections if
needed.
• Remove protective film if present from the control panel and
door.
Junction Box
• Check that tub trim does not contact the door.
Bracket
13