Fixing The Base To The Support - Videotec UEBP4 Manuel D'instructions

6.3 Fixing the base to the support

Use the screws and washers provided.
Apply thread-locker into the holes for
screws (Loctite 222®).
Pay attention to the fixing. Tightening
torque: 4.5Nm (±0.2Nm).
Fasten the base (01) on the support (02) using the
screws and washers (03).
03
01
Fig. 7
6.4 Connection of the connector
board
The earth ground cable must always be connected
to the relevant terminal (GND).
The remaining 3 or 6 cables can be connected
to the connectors' board based on installation
requirements.
Refer to the PTZ camera manual for connection and
completion of PTZ camera installation.
4
6.5 Mobile connectors cabling
(Ethernet)
Use of Ethernet cables with the following
characteristics is highly recommended:
• Cable diameter: from 5mm (0.2in) up to 6mm
(0.24in).
• For the type of cable, refer to the PTZ camera
manual.
Cable the mobile connector by operating as follows.
Insert the Ethernet cable using the sealing nut (01),
the cage (02), the gasket (03) and the body of the
connector (04).
Fig. 8
02
Crimp connector RJ45.
Carry out the connections as described in the table
(according to the standard specifications: TIA/EIA-
568-B) (Tab. 1, page 4).
CONNECTION OF THE ETHERNET CABLE
Pin number
1
2
3
4
5
6
7
8
Tab. 1
03 01
04 02
Cable colour
Orange-White
Orange
Green-White
Blue
Blue-White
Green
Brown-White
Brown
MNVKUEBP4_2222_EN