Safety Instructions - Zanussi ZRB24100WA Notice D'utilisation

• Do not use electrical appliances inside the food storage compart-
ments of the appliance, unless they are of the type recommended by
the manufacturer.
• Do not use water spray and steam to clean the appliance.
• Clean the appliance with a moist soft cloth. Only use neutral deter-
gents. Do not use abrasive products, abrasive cleaning pads, solvents
or metal objects.
• Do not store explosive substances such as aerosol cans with a flam-
mable propellant in this appliance.
• If the supply cord is damaged, it must be replaced by the manufac-
turer, its service agent or similarlyqualified persons in order to avoid a
hazard.

Safety Instructions

Installation
Warning! Only a qualified person must
install this appliance.
• Remove all the packaging.
• Do not install or use a damaged appliance.
• Obey the installation instruction supplied
with the appliance.
• Always be careful when you move the ap-
pliance because it is heavy. Always wear
safety gloves.
• Make sure the air can circulate around the
appliance.
• Wait at least 4 hours before connecting the
appliance to the power supply. This is to
allow the oil to flow back in the compressor.
• Do not install the appliance close to
radiators or cookers, oven or hobs.
• The rear of the appliance must stand
against the wall.
• Do not install the appliance where there is
direct sunlight.
• Do not install this appliance in areas that
are too humid or too cold, such as the
construction appendices, garages or wine
cellars.
• When you move the appliance, lift it by the
front edge to avoid scratching the floor.
www.zanussi.com
ZANUSSI_ZRB24100WA-ZRB24100XA_CS-HU.indd 27
All manuals and user guides at all-guides.com
Electrical connection
• The appliance must be earthed.
• All electrical connections should be made
• Make sure that the electrical information on
• Always use a correctly installed shockproof
• Do not use multi-plug adapters and exten-
• Make sure not to cause damage to the
• The mains cable must stay below the level
• Connect the mains plug to the mains
• Do not pull the mains cable to disconnect
Warning! Risk of fire and electrical
shock.
by a qualified electrician.
the rating plate agrees with the power sup-
ply. If not, contact an electrician.
socket.
sion cables.
electrical components (e.g. mains plug,
mains cable, compressor). Contact the
Service or an electrician to change the
electrical components.
of the mains plug.
socket only at the end of the installation.
Make sure that there is access to the mains
plug after the installation.
the appliance. Always pull the mains plug.
27
2016-02-16 11:00:38