Allocating The Progress Display; Terminating The Configuration Mode - ELV Electronik WS300 Notice D'emploi

BA 65 01 55 04.05.2004
46
7:19 Uhr Seite 46
Selecting the unit for rainfall
measurement
The unit for the rainfall quantity is displayed in the field "RAIN"
where you can chose between l/m
Select the desired unit using the keys "+" and "-".
Press the "NEXT" key. After that, you can allocate the progression
display.

Allocating the progress display

You can allocate the following display types to the graphic progres-
sion display:
• atmospheric pressure
• interior temperature
• exterior temperature
If the progress display is allocated to one of the two temperature
displays, the symbol "
addition.
Overlay/identification in the display field:
P = atmospheric pressure
O = outdoor temperature
I = indoor temperature
Select the desired allocation using the keys "+" and "-".
Press the key "NEXT", after that, the unit for the wind velocity mea-
surement can be entered.
Selecting the unit for wind velocity
The following units can be set:
km/h = kilometre per hour
m/s = metre per second
mph = miles per hour
The display will take place in the field "WIND".
Select the unit with which you wish to display the wind velocity
using the keys "+" and "-".
If the "NEXT" key is pressed, the year will appear again; the
input order can commence from the beginning again. You
could now, for example, monitor or alter the entries.
Terminating configuration mode
Press "EXIT" to complete input. This can take place at any desired
position, e.g. after setting the time etc.
2 or mm.
"appears in the display field concerned in