Commissioning Additional Sensors; Commissioning The Base Station - ELV Electronik WS300 Notice D'emploi

BA 65 01 55 04.05.2004
When selecting the installation site, take the safety of children, pets, vehicles, etc
into consideration.
Any risk of the combination sensor's falling poses the risk of injury or danger of dam-
aging vehicles or other objects.
You can also use a hammer to insert the earth peg into the ground. However, use a
suitable piece of wood or similar in order not to damage the top end of the pipe as
this makes it impossible to connect the other pieces of pipe (loss of warranty)!
Make sure that there are no pipes or similar installed in the area where you wish to
insert the peg into the ground (e.g. hoses for irrigation systems or similar).
b) Commissioning additional sensors
If you wish to use one or several additional temperature / humidity sensors of the type "ASH2200", insert the
batteries now into the sensor(s) with the right polarity. You can operate up to 8 sensors.
c) Commissioning the base station
• Open the battery compartment on the back of the base station (remove the
installation base, if applicable).
• Insert four batteries (LR6/mignon/AA) with the correct polarity into the bat-
tery compartment.
Use preferably alkaline batteries.
It is possible to use accumulators but these reduce the operational life
due to their lower voltage / capacity.
• Close battery compartment.
• After you have inserted the batteries, all segments of the LCD are displayed
briefly.
• After that, the base station activates the synchronisation mode for 15 minutes. During this period, the
device displays all received radio weather sensors in succession.
If all sensors used have already been received, you can terminate synchronisation mode prematurely by
pressing any key.
• Normal display of all weather data takes place after synchronisation. Only the sunset and sunrise togeth-
er with the moon phase are not yet displayed because the time and the calendar have to be set for this
purpose.
• You can either hang the base station on a wall (there is a corresponding opening on the back) or place it
on a level surface with the installation base.
• If you wish to use the installation base, first hook the short claws of the base into the holders on the back
of the base station. Afterwards, tilt the base forward until the claws snap into place in the holders on the
bottom of the base station.
7:19 Uhr Seite 41
below
41