Calling Up Configuration Mode; Setting Time And Date; Entering Longitude And Latitude - ELV Electronik WS300 Notice D'emploi

BA 65 01 55 04.05.2004
44
7:19 Uhr Seite 44
Calling up configuration mode
Press key "IN" for approx. 2 seconds. When the key has been
released, the corresponding display appears.
You can leave the configuration mode at any time by pressing
"EXIT" (= "SENSOR"), see "Terminating configuration mode".

Setting time and date

Set current year using the keys "+" and "-".
Press "NEXT" key.
Set current month using the keys "+" and "-".
Press "NEXT" key.
Set current day using the keys "+" and "-".
Press "NEXT" key.
Set minutes using the keys "+" and "-".
Press "NEXT" key.
Set hours using the keys "+" and "-".
Press key "NEXT"; then you can set the latitude ("LA" appears on the
display).
Entering latitude/longitude
It is necessary to state the location of the weather station in order to
calculate the sunset/sunrise times.
You can enter the latitude at a range of between –60.0° to +60.0°.
The manufacturer's setting is Berlin. You can determine your position
in different ways:
• in chapter 18 on page 61, you will find a table with the coordinates
of several German cities. Select a nearby location near and enter
its coordinates.
• if you have a GPS navigation device, e.g. in your car or a mobile
device, you can adopt its position details and thus the exact posi-
tion.
• you can also obtain the exact co-ordinates in the Internet. There
are numerous sites that deal with navigation.
Please observe the fact that the information concerning the sunrise /
sunset would only be correct to be exact at the sea of for complete-
ly level landscape. Mountains, high forests etc. will alter these values
for your location.
Even for the ideal situation, the information can deviate by some
minutes as an approximation formula is used for the calculation.