Dacor DDW24M99 Serie Consignes D'installation page 15

STEP 4 Install the custom panel (FBI models only (DDW24T999BB/DA))
Ø 2
C
DACOR_DW9500M_DD68-00197A-01_EN.indd 15
A
B
B
C
1. Insert the supplied rubber skirt (A) into
the 3 holes at the bottom of the door.
2. Put the installation template on the
back of the custom panel and fix it
temporarily using transparent tape.
Note that the rear of the custom panel
will be attached to the dishwasher door.
CAUTION
• The top end of the custom panel must
be aligned with the top end of the
installation template.
• Use a custom panel between 7 lbs and
20 lbs.
3. Pre-drill the 6 points marked on the
installation template using a 2-pi drill
bit to a depth of 10 -12 mm.
4. Remove the installation template and
tighten the custom panel fixers (B) at
the top with 2 screws (C, Ø4 X 20) as
shown.
English 15
2017-08-23 8:54:54