Hendi 154601 Mode D'emploi page 9

•
H
D
Intended use
• The device is intended for professional use and
can be operated only by qualified personnel.
• This appliance is designed only for grilling appro-
priate food products. Any other use may lead to
damage to the appliance or personal injury.
Connecting the gas bottle
1 = Main tap
2 = Pressure regulator
3 = Gas hose
4 = Gas Bottle
5 = Rubber washer
Igniting the gas appliance
• Press the knob and turn left to the maximum po-
sition. Keep the knob pressed and press the igni-
tion button a few times. Keep the knob pressed in
for approximately 10 more seconds. The burner
will continue to burn.
Turning off the gas appliance
• Turn the knob fully to the right.
Note! After turning off the burners, wait approxi-
mately 10 minutes before reigniting the burners.
The maximum cylinder dimensions(regulator included) should not
exceed (D)50x(H)75cm if no cylinder compartment included.
• Operating the appliance for any other purpose
shall be deemed a misuse of the device. The user
shall be solely liable for improper use of the de-
vice.
Attach the pressure regulator to the gas bottle
using the large brass nut. Always ensure that the
rubber-sealing washer is present in the nut. (NB.
This rubber washer is not required for UK-type
pressure regulators). Tighten the nut well. Note
that the nut has a left-hand thread.
Check the connections for leaks using a soap and
water solution.
Every time a newly filled gas bottle is connected, a
new rubber washer must be fitted. In most cases,
your gas supplier will include it with the bottle.
• Let the appliance burn for approximately 15
minutes before putting meat on the grid, as the
burners must first heat the chamber before it can
pass its heat to the upper grid.
• When disconnecting the gas bottle or after turn-
ing off the burners, always turn off the regulator
on the gas bottle!
EN
9