Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
1.
Select the USB port (click on Refresh, if necessary).
2.
Select the upgrade file and click on Upgrade.
3.
Wait until the device reboots.
Check the firmware status in the "Maintenance"
4.
menu under "System Info".
Note
Upgrades via FTP are made in the same
way as detailed above.
The PC must be in the same local network.
Set up a PC as an FTP server.
Enter the IP address of the FTP server .
Default
Note
In this process, the device is reset to the factory de-
fault settings.
Warning
All settings made since the start of operation
are deleted (cameras, recording settings,
alarms etc.)!
Avoid data loss by backing up the settings in
advance. These can be imported again follow-
ing the system reset.
115
All manuals and user guides at all-guides.com
Network
TAB network load
The amount of received and sent data is displayed
graphically.
Depending on the network settings, the status and infor-
mation for one or two network connections is shown in
the field underneath the graph.
Note
Information regarding the network traffic and net-
work interfaces are shown here.
Maintenance
Publicité
Table des Matières
