Hdd Management Parameters; Installing The Hdd - Abus TVHD80120 Notice D'utilisation

HDD
HDDs
Note
The device can manage four 3.5" SATA hard disk
drives.
Each of the installed HDDs must be initialised be-
fore the device can be used for recording. The de-
vice only detects the HDD and its assignment af-
ter initialisation has been made.
Warning
All data is deleted from the HDD during initialisa-
tion.
Ensure a data backup has been made in good
time beforehand.

Installing the HDD

1. Disconnect the device from the mains power and
open the cover.
2. Observe the applicable ESD guidelines when han-
dling electronic devices and ensure they are earthed.
3. Do not open the device in rooms with carpets or
other surfaces that can become electro statically
charged.
4. Avoid bodily contact with all components on the
PCB.
Warning
If you have questions regarding the information or
cannot find the information you need, please con-
tact your maintenance specialist.
5. Install the HDD and then connect it.
6. Reattach the cover and connect the device to the
mains power supply.
Note
If the initialised HDD is not displayed, check the
connections
Click on "HDD" in the menu to define settings relating to
hard disc administration
107
All manuals and user guides at all-guides.com

HDD Management parameters

HDD information
No.
Capacity
Status
Features
Type
Free Space
Delete
1.
2.
3.
4.
5.
Shows the internal connection
number
HDD capacity (in GB)
Shows the current status of the
HDD:
Not initialised
Normal
Error
Standby

Read-only: Read-only protec-
tion

R/W: Read and write
Local: Device HDD
NFS: Network HDD
If possible, avoid using NFS stor-
age due to compatibility problems
that may occur.
Shows the approximate free
memory for recordings
Remove the hard drive
Select the HDD by ticking the corresponding box.
Start the process by clicking on Init.
Confirm the prompt by pressing OK.
The status bar shows the progress of the initialisa-
tion.
Nach Beendigung des Vorgangs erscheint die Fest-
platte.
HDD