Spark Plug Maintenance; Inspect Muffler And Spark Arrester - Firman H03651 Manuel Du Propriétaire

Spark Plug Maintenance

Changing the spark plug will help your engine
to start easier and run better.
(a) Remove the spark plug cap.
(b) Remove spark plug using provided wrench.
A
B
A- Spark plug
B- Spark plug cap
( c) Inspect spark plug for damage and clean
with a wire brush before reinstalling
(d) Adjust the electrode gap to 0.7 to 0.8 mm
(0.028" to 0.031").
(e) Seat spark plug in position and thread by
hand to prevent cross threading.
(f) Tighten plug with provided wrench and put
the cap back on spark plug.
SPARK PLUG: TORCH F6RTC
NGK BPR6ES
CHAMPION RN9YC equivalent.
English

Inspect Muffler and Spark Arrester

Inspect the muffler for cracks, corrosion, or
other damage. Remove the spark arrester, if
equipped, and inspect for damage or carbon
blockage. If replacement parts are required,
make sure to use only original equipment
replacement parts.
WARNING
Exhaust heat/gases could ignite combustibles,
structures or damage fuel tank causing a fire,
resulting in death or serious injury and/or
property. Contact with muffler area could cause
burns resulting in serious injury.
•
DO NOT touch hot parts and AVOID hot exhaust
gases.
•
Allow equipment to cool before touching.
•
Keep at least 5 feet (1.5 m) of clearance on all
sides of generator including overhead.
•
Replacement parts must be the same and
installed in the same position as the original
parts.
Clean or replace spark arrester as follows:
Depending on the type fuel used ,the type and
amount of lubricant used, and/or your operating
conditions, the exhaust part and muffler may
become blocked with carbon deposits. If you
notice power loss, you may need to remove these
deposits to restore performance.
1. Allow the engine to cool completely before
servicing the spark arrester.
2. Remove the screws securing the spark arrester
in place and the remove it from muffler.
Page 29
Customer Service: 1-844-FIRMAN1