Step 6 - Canopy Removal / Cup Holder Assembly - GAGGLE Compass 9908932 Instructions De Montage

To remove canopy:
1.
Open sides of canopy around stroller handle by
pulling fabric hook & loop fasteners apart (1)
(Fig. 1).
2.
Pull rear panel of canopy up and out of opening
between stroller handle and handle support (2).
3.
Remove canopy from rear support tube by
releasing hook & loop fasteners.
4.
Remove screw,retainer, and canopy strap
from handle. (Fig. 2)
5.
Remove rear canopy tube (short tube) by
pressing retainer tab in (1) and sliding rear
canopy tube up (2) (Fig. 3).
6.
Repeat step 5 for opposite side of stroller.
7.
Remove main canopy tube (long tube) by pressing
retainer tab in (1) and sliding main canopy tube up
(2) (Fig. 3).
8.
Repeat step 7 for opposite side of stroller.
Cup Holder Assembly
Push down Cup Holder (J) to secure in
place. Cup Holder key slot fits into
button on side of stroller handle.
See Figure 1.
Only use Gaggle
approved accessories for this
stroller.
STEP 6 - Canopy Removal
Cup Holder Assembly
®
provided or
Stroller
Handle
Canopy
Strap
J
Fig. 1
8
Fig. 1
2
1
1
Fig. 2
Fig. 3
2
1
Retainer Tab
AB20049_G19