Step 3 - Front Wheel Assembly; Step 4 - Arm Bar Assembly - GAGGLE Compass 9908932 Instructions De Montage

1.
Align pivot shaft of stroller frame with hole in
wheel assembly. Wheel locking lever should be facing
up. Slide wheel assembly onto pivot shaft until a solid
click is heard and felt from the buttons engaging.
(Fig. 1)
2. Check the wheel is secure by pulling down on the
wheels. Wheels should stay securely in place.
1. With arrow on arm bar (E) facing up, slide Arm Bar
Clamp (1) between fabric seat side cover and front leg.
2. Push Arm Bar Clamp (1) onto front leg and align the
hole in the clamp with the stud (2) on the arm, on both
sides of the stroller (Fig. 2)
3. Lock Arm Bar to stroller frame by pushing Arm Bar
Clamp (1) around front leg tube (4) . Close the lock lever
by pressing the lock lever onto the arm bar until it clicks
closed and the stud (2) is fully through the hole in the
lever. (Fig. 3).
4. Repeat steps 2 & 3 for opposite end of Arm Bar.
Check that the Arm bar is securely attached.

STEP 3 - Front Wheel Assembly

STEP 4 - Arm Bar Assembly

4
6
E
E
1
Fig. 1
AB20049_G4
Fig. 1
1
Fig. 2
1
2
Fig. 3
2