Electrical Connection - Panasonic CQ-RG131U Manuel D'instructions

Electrical Connection

This unit can be connected to an optional CD changer (CX-DP88U). For details consult your
nearest Panasonic Servicenter.
For connection to a CD changer, refer to the operating instructions of the CD Changer
(CX-DP88U).
Cautions:
To prevent damage to the unit, be sure to follow the connection diagram below.
Remove the covering of the leads about 5 mm long from their end before connecting.
Do not insert the power connector into the unit until the wiring is completed.
Be sure to insulate any exposed wires from a possible short-circuit from the car chassis. Bundle
all cables and keep cable terminals free from touching any metal parts.
Extension Corel
(DIN/BATT/RCA/GND)
Fuse(3A)
BATTERY
Battery Lead
RCA Cord
(Red)
(R)
DIN Cord
Antenna
PREAMP OUT CONNECTOR
(Rear)
SPEAKER LEAD
(Gray w/Black Stripe)
(White w/Black
Stripe)
(White)
(–) (+)
(–) (+)
LEFT SPEAKER RIGHT SPEAKER
(FRONT )
(FRONT )
(L)
(White)
CD Changer
Control Connector
CQ-RG131U
CD-CH IN
L(White)
R(Red)
Fuse(12A)
Resistor(1kΩ)
(Violet w/Black Stripe)
(Green w/Black
(Green)
(Gray)
Stripe)
(–) (+)
LEFT SPEAKER
(REAR )
CD Changer
CX-DP88U
Ground Lead
(To a clean, bare metallic
part of your car)
DIN Extension Cord
Battery Lead
Power
To the car battery, continuous
Connector
+12V DC
ACC Power Lead
(Yellow)
to ACC power, +12V DC
(Red) Ground Lead
to a clean, bare metallic part of
the car chassis
(Black)
Antenna Control Cord
to the auto antenna control power
(Blue)
cord of the car
External Amplifier
Control Power Lead
To an external amplifier
(Violet)
(–) (+)
RIGHT SPEAKER
(REAR )
CQ-RG131U
E
N
G
L
I
S
H
18
27