Assembling The Auger - Toro 58630 Mode D'emploi

Assembling the Auger

1. Insert the output shaft on the powerhead into the
open end of the auger
2. Secure the powerhead to the auger using the
bolt (3/8 x 1-1/2 inches) and locknut (3/8 inch)
as shown in Figure
3. Secure the fishtail point to the auger
1. Output shaft on the
powerhead
2. Locknut (3/8 inch)
3. Bolt (3/8 x 1-1/2 inches)
(Figure 3).
3.
(Figure
Figure 3
4. Auger
5. Fishtail point
3).
g356736
6