Varian MidiVac 929-5000 Notice De Mode D'emploi page 26

USE
This paragraph describes the fundamental operating
procedures. Detailed information
procedures that involve optional connections or options
are supplied in the paragraph "USE" of the appendix
"Technical Information".
Make all vacuum manifold and electrical connections
and refer to the connected pump instruction manual
prior to operating the controller.
!
WARNING!
To avoid injury to personnel and damage to the
equipment, if the controller is laying on a table make
sure it is steady.
All manuals and user guides at all-guides.com
and operating
1) "Remote I/O" connector for remote control
2) Port available for "Set Point" connector (optional)
3) Port available for serial connector (optional)
4) Screw for interlock cable connection
5) Port available for second interlock cable input (optional)
6) Port available for second HV connector (optional)
7) HV connector
8) Interlock cable input
9) Interlock cable
10) Fuses
11) Mains plug
12) Mains switch
Controller Rear Panel
21
INSTRUCTIONS FOR USE
MidiVac Front Panel Controls and Indicators
The figure and the table of the following page illustrate
the MidiVac front panel controls and indicators with
relevant description and function.
NOTE
Some controls and indicators change their function and
meaning according to the position of HV ON OFF
switch. The table describes all function and meaning.
MidiVac Rear Panel
The MidiVac controller rear panel controls and
connections are shown in the following figure.
For detailed information about the connections see the
appendix "Technical Information".
87-900-080-01 (D)