Assembly; Attaching / Removing Nozzles; Use - Cleanmaxx PC-P003WH Mode D'emploi

Assembly

Attaching / Removing Nozzles

• Plug the nozzle you want as far as it will go into the suction opening on the front of
the collecting container and check that it fi ts securely.
• To remove a suction nozzle, pull it out of the suction opening.
Removing / Inserting the Collecting Container

Use

PLEASE NOTE!
■ Always switch off the device before replacing any accessories.
■ Pay attention to the collecting container's MAX mark. If the mark is reached during
use, empty the collecting container. The fi lter compartment and the fi lter must also
be cleaned regularly to prevent the motor from being overloaded.
■ Do not use the device when it is connected to the adapter.
• Switch the device off after each surface has been cleaned as this will consider-
ably increase the operating time on each battery charge.
• If the suction power diminishes even though the battery is full, empty the col-
lecting container.
1. Place one of the nozzles into the suction opening. However, you can also use the
vacuum cleaner without a nozzle.
2. Press the On / Off switch to switch on the device.
3. Guide the nozzle or suction opening over the surface to be cleaned.
4. To switch off the vacuum cleaner, press the On/Off switch.
5. Empty the collecting container after use. Clean the fi lter compartment and the fi lter
on a regular basis (see the "Cleaning and Storage" chapter).
6. Charge up the battery again (see the "Charging Up the Battery" chapter).
HS2in1_DE-EN-FR-NL_A5_V9.indb 19 HS2in1_DE-EN-FR-NL_A5_V9.indb 19
19
• Removing: Hold the device with the collecting container point-
ing downwards. Press the release button of the collecting con-
tainer and remove the main unit from the collecting container.
• Inserting: On the bottom edge of the main unit there is a lock-
ing lug. Plug this into the associated slot in the collecting con-
tainer. Then press the two parts of the device together at the top
until the locking mechanism is heard to lock in place. It may be
necessary to press the release button here. Then check wheth-
er the collecting container is fi tted in place properly.
■ IMPORTANT: If there is liquid in the collecting container, do
not overfi ll it and do not turn the device over with the top
pointing downwards! Otherwise water could get into the
ventilation opening in the fi lter compartment and thus to the
motor.
EN
06.08.2018 11:40:06 06.08.2018 11:40:06