Assembly; Operation - Cleanmaxx PC-P008E Mode D'emploi

EN

Assembly

Attaching / Removing Nozzles
With the exception of the electrical fl oor nozzle (9), all nozzles are attached with the aid
of the nozzle adapter (12).
• Plug the nozzle adapter into the suction opening (8) or the articulated suction tube.
Plug the nozzle you want onto the nozzle adapter.
• To take them apart, pull the nozzle and the adapter apart.
Attaching / Removing the Floor Nozzle and Articulated Suction Tube
No adapter is required for the electrical fl oor nozzle (9) and the articulated suction tube.
• They are plugged directly onto the suction opening (8). The catches must be heard
to engage in place. Attach the electrical fl oor nozzle to the articulated suction tube
in the same way.
Removing / Inserting the Dust Container
closed
open

Operation

PLEASE NOTE!
■ Make sure that there are no large, pointy objects on the area to be cleaned.
■ Pay attention to the dust container's MAX mark. If the mark is reached during use, em-
pty the dust container. Empty and clean the dust container after each use. The HEPA
fi lter must also be cleaned regularly to prevent the motor from being overloaded.
■ Switch the device off after each surface has been cleaned as this will considerably
increase the operating time on each battery charge. Charge up the battery after use
(see the "Charging Up the Battery" chapter).
When the device is switched on, the charge status of the battery (4) is indicated
by the two green battery charge status lamps (1). If both lamps are lit up, the
battery is full. If only the red operating lamp (1) is lit up, the battery needs to be
charged up.
1. Select an accessory as required (see the "Device Overview" chapter – "Accesso-
ries") and attach it to the device (see the "Assembly" chapter).
24
• To detach it, press the release button and pull the electri-
cal fl oor nozzle or the articulated suction tube out at the
same time.
• Removing: Twist the dust container (7) a little bit. It is re-
leased from the main unit (3) and can be removed.
• Inserting: Insert the dust container into the main unit. Ro-
tate it slightly as you do this until it engages in the main unit
correctly. Then twist the dust container in the main unit to
secure it in place. The release button of the dust container
must be located below the suction opening (8) after it has
been attached.